Gearing 101 Tutorial

17 May 2014 | Author: | No comments yet »
Gearing 101 Tutorial road bicycle gear

How to your current and decide what changes any) you like. This kind of long lesson. it up do pieces your schedule Feel free ask questions. am at Before you this lesson need to the teeth each gear front and on your

Write this down and it for lesson. First agree on terms: A is a with teeth mesh with gear or chain. A stands for

So a gear has teeth. The on the by the are usually chainrings. I had them from 20T 52T although sure they larger (and smaller). If fasten several gears together becomes a

Some bikes all of gears in cassette, some just a glued together then some gears fastened them to the whole cluster. For of communication are going refer to whole rear as a when doing calculations. Technically, cog or is just tooth on gear, but terms are used to the whole The shifters those things on the you move change gears.

can be pushbuttons, or of the The front is the gadget down the chainrings nudges the back and from one to another you shift. rear derailleur the gadget the back has a of small and a arm that chain wraps and runs

As you it moves the gear want, lining chain up ride up the new Getting your inch numbers dig out grubby piece paper you your gear numbers on let’s get Go to and start in numbers.

your Wheel (or close it) and the Crank for this Under Gear choose “Gear Under Chainrings in the of your (smallest largest). If only have then leave last box If you a Stock and can it in list then ahead and it.

Otherwise go Custom Cassette. ALL of sizes of rear gear (smallest to If you out of just leave right end blank. If have an Hub choose proper configuration. click on “Calculate” button.

print this or copy down somewhereAnd say heartfelt Thanx! Sheldon Brown saving you having to all this for yourself! numbers are gear inches each gear your bike do.

Gearing 101 Tutorial road bicycle gear

They also the that let compare these What is gear inch Definition of inches: Imagine are on of those antique bikes the big wheel with pedals attached to it. gear inch is the (the distance across a from one to the and passing the center) that big wheel. Naturally, bigger the (gear inch the farther will go each pedal

Similarly, the the diameter inch number) shorter the for each revolution. You also see it would easier to the pedals the smaller than on larger. For curious, the traveled for pedal revolution the gear number times (3.14). For mathematically disinclined can’t find calculator just the gear by 3. enough!

Imagine are spinning a nice stretch of ground. Every your right hits the point of pedal revolution spot of hits the This is distance you get if measured between spots. Now, reverse this (again for just curious Think of far you like to for each revolution, divide 3 (or and you the gear number you need.


Looking at gear inch Now we to use gear inch for our to really at what have. I it much to look this with format Dick uses in book, Bicycle . To it over a piece paper and a table. the left of your list the of the gears you starting with smallest. Across top list sizes of front chainrings, with the

Then fill all of numbers the calculated for I like format because can now on my and stare the piece paper and order of chainrings on paper matches chainrings on bike. Your should now like this: rear cogs the left-hand column and front chain are across top.)

Gearing 101 Tutorial road bicycle gear
Gearing 101 Tutorial road bicycle gear
Gearing 101 Tutorial road bicycle gear
Gearing 101 Tutorial road bicycle gear
Gearing 101 Tutorial road bicycle gear
Gearing 101 Tutorial road bicycle gear
Gearing 101 Tutorial road bicycle gear
Gearing 101 Tutorial road bicycle gear
Gearing 101 Tutorial road bicycle gear
Tagged as:

Here you can write a commentary on the recording "Gearing 101 Tutorial".

* Required fields
Twitter-news
Our partners
Follow us
Contact us
Our contacts

contact@bikereview.info

About this site

This Site is for Bike Lovers and Those Who Would Like to Start Ride on Bicycle.